Canon Booklet Finisher-D1 Service Manual page 257

5
Adjustment > Auxiliary Adjustment > Adjusting Delivery of Staple Stack (lower delivery) > Procedure
7) If B (displacement amount between the 1nd sheet and the 3rd sheet) is out of the specified
value, execute the following work:
Press push switch SW385 [1] once to get into the adjustment mode for B (displacement
amount between the 1nd sheet and the 3rd sheet). Pressing push switch SW383 [2]
reduces the displacement amount while pressing SW384 [3] increases the displacement
amount. (Correction amount is displayed on the LED [4])
• Adjustment range: +48 to -48 (correcting amount per 2units: 0.4mm)
(Adjustment level: amount per 2 units)
Press SW385 again to confirm correction amount for A and B.
SW382
SW381
SW383 SW384 SW385
(-) (+)
[2]
CAUTION:
Every time you press push switch SW385 while the LED indicates "0", the correction
amount for A and B is alternately displayed on the LED.
During the work, be sure to remember which correction value you are working.
5 Adjustment > Auxiliary Adjustment > Adjusting Delivery of Staple Stack (lower delivery) > Procedure
[4]
ENTER
[3] [1]
F-5-187
5-81
5-81