Canon Booklet Finisher-D1 Service Manual page 104

4
Parts Replacing and Cleaning > Feed Assembly > Removing the Upper Feed Unit > Procedure
5) While opening the Upper Feed Unit [1], remove the Damper Shaft [2].
• 1 Screw [3]
6) Place the 2 Grounding Wires [1] and the harness [2] on top of the finisher by putting them
through the hole [A] and the gap [B].
[A]
[2]
[1]
4 Parts Replacing and Cleaning > Feed Assembly > Removing the Upper Feed Unit > Procedure
[1]
[2]
[3]
F-4-79
[B]
F-4-80
7) Slide the 2 Hinge Pins [1], and remove the Upper Feed Unit [2].
[2]
[1]
4-41
[1]
F-4-81
4-41