Removing The Tray A Unit - Canon SADDLE FINISHER K3 Service Manual

CHAPTER 3 MECHANICAL SYSTEMS

1.3.2 Removing the Tray A Unit

1) Open the upper cover, and detach the
support pole cover.
2) Remove the rear cover and the rear up-
per cover.
3) Remove the stopper (upper).
4) Disconnect the two connectors [1], and
remove the screw [2] to detach the
grounding wire [3].
5) Free the harness [5] from the cord
clamp [4]; then, remove the two screws
[6], and detach the harness holder [7].
6) Pull off the tray A unit [8] upward.
1.3.3 Removing the Tray B Unit
1) Remove the tray A unit.
2) Remove the stopper (lower).
3) Open the upper cover.
4) Disconnect the connector [1], and re-
move the screw [2] to detach the
grounding wire [3]; then, free the sharp-
ness [5] from the cord clamp [4].
5) Remove the two screws [6], and detach
the harness holder [7].
3-20
COPYRIGHT© 2001 CANON INC.
[2]
2000 2000 2000 2000 CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
[7]
[3]
[5] [4]
[1] [1]
F03-103-03
F03-103-04
[4] [5]
[1]
[2] [3]
F03-103-05
[6]
[8]
[7]
[6]