Canon Booklet Finisher-D1 Service Manual page 170

4
Parts Replacing and Cleaning > Saddle Stitcher Assembly > Removing the Press Roller Unit > Procedure
CAUTION:
When installing the Slide Shaft (Lower), make sure that the hole [1] of the Press Roller
Unit Cover and the hole [2] of the knob are overlapped while the Press Roller Unit is at
the rear end.
8) Move the Slide Shaft (Upper) [1], and remove the Press Roller Unit [2].
[1]
[2]
4 Parts Replacing and Cleaning > Saddle Stitcher Assembly > Removing the Press Roller Unit > Procedure
[1] [2]
F-4-266
F-4-267
9) Remove the Slide Shaft (Upper) [2] from the Press Roller Unit [1].
4-107
[2]
[1]
F-4-268
4-107