Adjusting Alignment Plate Position; Preparations; Procedure - Canon Booklet Finisher-D1 Service Manual

5
Adjustment > Adjustment at Time of Parts Replacement > Adjusting Alignment Plate Position > Procedure

Adjusting Alignment Plate Position

This adjustment is executed when replacing or installing/removing the Front Alignment Motor
or Rear Alignment Motor or when replacing the Finisher Controller PCB.
Adjusting method is as follows:

■ Preparations

1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).

■ Procedure

1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
In the case of A-configuration size:
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
5 Adjustment > Adjustment at Time of Parts Replacement > Adjusting Alignment Plate Position > Procedure
ENTER
F-5-57
In the case of L-configuration size:
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
2) Press switch SW385 [1] to start width adjustment of the front alignment plate.
SW382
SW381
SW383 SW384 SW385
(-) (+)
ENTER
F-5-58
ENTER
[1]
F-5-59
5-27
5-27