Canon Booklet Finisher-D1 Service Manual page 310

5
Adjustment > Auxiliary Adjustment > Punch skew tolerance adjustment mode > Procedure
2) Press the Push Switch SW385 [1] to complete preparation for the adjustment.
SW382
SW381
SW383 SW384 SW385
(-) (+)
3) By pressing the Push Switch SW383 [1] or SW384 [2], skew correction amount can be
selected.
Every time SW384 [2] is pressed, "1: 2 mm/2: 4 mm/3: 6 mm" is displayed on the LED [3].
[3]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1] [2]
5 Adjustment > Auxiliary Adjustment > Punch skew tolerance adjustment mode > Procedure
ENTER
[1]
F-5-331
F-5-332
4) Press the Push Switch SW385 [1] to determine skew correction amount, and complete the
adjustment.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1]
F-5-333
5-134
5-134