Adjusting The Height Of Corrugation Roller For Stack Delivery; Preparations; Procedure - Canon Booklet Finisher-D1 Service Manual

5
Adjustment > Adjustment at Time of Parts Replacement > Adjusting the Height of Corrugation Roller for Stack Delivery > Procedure
Adjusting the Height of Corrugation Roller for Stack
Delivery
Execute the adjustment in the following cases.
• When replacing the Finisher Controller PCB
Adjusting method is as follows:

■ Preparations

1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).

■ Procedure

1) While supporting the Tray B [1], insert a screwdriver into the hole [A] to release the block [2]
in the direction of [B], and lower the Tray B [1] by approximately 20 cm from the lower edge
of the Neat Stack Unit (Lower) Cover [3].
[3]
[1]
5 Adjustment > Adjustment at Time of Parts Replacement > Adjusting the Height of Corrugation Roller for Stack Delivery > Procedure
[2]
[B]
[A]
F-5-43
2) Remove the Stack Delivery Roller Upper Static Eliminator [1].
• 4 Screws [2]
x4
[1]
5-22
[2]
F-5-44
5-22