Saddle Stitch Adjustment - Canon Booklet Finisher-D1 Service Manual

5
Adjustment > Auxiliary Adjustment > Saddle Stitch/Fold Placement Adjustment > Saddle stitch adjustment
3) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
Then, press SW385 once so that the adjustment is ready now.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
4) Work with the 2 push switches (SW383, 384) by calculating correction value from the
measured value.
Pressing SW383 [1] moves the folding position [2] upward while pressing SW384 [2] moves
the folding position [2] downward.
• Adjustment range: +16 to -16 (correction amount per unit: 0.125mm)
[2]
5) Press push switch SW385 once to complete the adjustment mode.
5 Adjustment > Auxiliary Adjustment > Saddle Stitch/Fold Placement Adjustment > Saddle stitch adjustment
ENTER
F-5-195
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1] [3]
F-5-196

■ Saddle stitch adjustment

NOTE:
In saddle stitch adjustment, the saddle stitch position and the fold placement are shifted
at the same time. By adjusting the saddle stitch position, the fold placement is also
shifted to the center at the same time.
● Preparation
1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
● Procedure
1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
• In the case of A-configuration [2]
• In the case of L-configuration [3]
Then, press SW385 so that the adjustment is ready now.
[2]
[3]
5-86
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-197
5-86