Procedure - Canon Booklet Finisher-D1 Service Manual

5
Adjustment > Auxiliary Adjustment > Side registration position fine adjustment mode (shift amount change) > Procedure

■ Procedure

1) Set DIP SW382 [1] on the Switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
2) Press the Push Switch SW385 [1] to complete preparation for the adjustment.
SW382
SW381
SW383 SW384 SW385
(-) (+)
5 Adjustment > Auxiliary Adjustment > Side registration position fine adjustment mode (shift amount change) > Procedure
ENTER
F-5-338
ENTER
[1]
F-5-339
3) By pressing the Push Switch SW383 [1] or SW384 [2], mode can be selected.
Every time SW384 [2] is pressed, "A: Mode setting/B: Adjustment value setting" is displayed
on LED [3].
Display [A] on LED [3] (select the mode setting mode).
4) Press the Push Switch SW385 [1] to determine the mode.
SW382
SW381
SW383 SW384 SW385
(-) (+)
[1]
5) By pressing the Push Switch SW383 [1] or SW384 [2], mode setting can be changed.
Every time SW384 [2] is pressed, "0: Disabled/1: Enabled stitching only/2: Enabled non-
stitching only/3: Enabled stitching/non-stitching" is displayed on LED [3].
6) Press the Push Switch SW385 [4] to determine the mode.
SW382
SW381
SW383 SW384 SW385
(-) (+)
[1]
[3]
ENTER
[2] [4]
F-5-340
[3]
ENTER
[2] [4]
F-5-341
5-137
5-137