Adjusting Alignment For Saddle Stapling - Canon Booklet Finisher-D1 Service Manual

5
Adjustment > Adjustment at Time of Parts Replacement > Adjusting Alignment for Saddle Stapling

Adjusting Alignment for Saddle Stapling

CAUTION:
Do not touch the drive parts because the finisher works without the covers during
checking for this adjustment.
This adjustment is executed when replacing or installing/removing the Saddle Stapler or when
staple positions (saddle delivery) are displaced at the rear side and the front side.
Adjusting method is as follows:
1) Open the front cover.
2) Remove the saddle inner cover (upper) [1].
• 1 knob [2]
• 2 screws [3]
5 Adjustment > Adjustment at Time of Parts Replacement > Adjusting Alignment for Saddle Stapling
3) Remove the saddle inner cover (lower) [1].
4) Turn ON the power of the finisher.
5) Turn ON the power of the host machine to be on to be on standby.
6) Open the front cover and put the door switch tool into the door switch.
7) Remove the switch cover.
[2]
NOTE:
Refer to "Preparations 5-6" for details of step 4) to 7).
[3]
[1]
8) Hold the lever [1] to pull out the saddle unit [2], and then open the saddle right guide [3].
[3]
F-5-146
• 4 screws [2]
• 1 knob [3]
[3]
[2]
[1]
[3]
[2]
[1]
5-63
[2]
F-5-147
F-5-148
5-63