Canon Booklet Finisher-D1 Service Manual page 213

5
Adjustment > Adjustment at Time of Parts Replacement > Adjusting Staple Position (2-stapling positions) > Procedure
3) Pressing switch SW383 [1] or SW384 [2] determines adjustment level.
By pressing SW383 once, the LED [3] indicates "-1" and the 2 stapling positions shift to the
upper side. In the same way, by pressing SW384 once, the LED [3] indicates "+1" and the
2 stapling positions shift to the lower side.
• Adjustment range: +20 to -20 (shifting amount per unit: 0.5mm)
[3]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1] [2]
4) Press switch SW385 [1] to move the stapler to the 2-stapling position.
SW382
SW381
SW383 SW384 SW385
(-) (+)
5 Adjustment > Adjustment at Time of Parts Replacement > Adjusting Staple Position (2-stapling positions) > Procedure
ENTER
[1]
F-5-83
5) Place A4 paper [1] on the intermediate process tray (Be sure to push in the paper to the
rear side of the process tray).
6) Check that the stapling position is within the specified range [1] (81.7 +/- 4mm for
A-configuration, 72.7 +/- 4mm for L-configuration). If the stapling position is out of the
specification, go through the procedure again from step 2).
F-5-82
7) Once the adjustment is complete, press SW385 to complete the adjustment mode.
CAUTION:
If the LED indicates anything other than "0" meaning the adjustment failure, execute the
adjustment again.
[1]
[1]
F-5-85
5-37
F-5-84
5-37