Table of Contents
Advertisement
5
Adjustment > Auxiliary Adjustment > Adjusting Position of Feed Belt > Procedure
Adjusting Position of Feed Belt
Execute this adjustment when replacing the feed belt of the intermediate process tray or
EEPROM on the finisher controller PCB, or in the case of variation in delivery stack.
Adjusting method is as follows:
■ Preparations
1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
■ Procedure
1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383
SW384 SW385
(-)
(+)
5
Adjustment > Auxiliary Adjustment > Adjusting Position of Feed Belt > Procedure
ENTER
F-5-157
2) Press switch SW385 [1] to start position adjustment of the feed belt.
SW382
SW381
SW383
SW384 SW385
(-)
(+)
3) Pressing switch SW383 [1] or SW384 [2] determines adjustment level.
By pressing SW383 once, the LED [3] indicates "-1" and the distance between the belt [4]
and the sheet interval [5] is reduced to increase feeding force of the belt. In the same way,
by pressing SW384 once, the LED indicates "+1" and the distance between the belt [4] and
the sheet interval [5] increased to reduce feeding force of the belt. (Adjustment range: +4 to
-4).
NOTE:
1. Increase feeding force by setting adjustment value to negative value (-1 to -4) in
the case of wear of the feed belt or using recycled paper (paper with large surface
resistance).
2. Reduce feeding force by setting adjustment value to positive value (+1 to +4) in the
case that dent on the paper edge is shown.
ENTER
[1]
F-5-158
5-69
5-69
Advertisement
Table of Contents
