Removing The Feed Belt; Preparation; Procedure - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Feed Belt > Procedure

Removing the Feed Belt

■ Preparation

1) Remove the Stack Wall (Lower).(Refer to page 4-29)
2) Remove the Stack Wall (Upper).(Refer to page 4-27)
3) Remove the Neat Stack Unit (Lower).(Refer to page 4-59)
4) Remove the Process Tray Unit.(Refer to page 4-62)

■ Procedure

1) Remove the guide [1].
• 1 Screw [2]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Feed Belt > Procedure
[1]
[2]
F-4-165
2) Loosen the screw [1] to move the Coupling (Rear) [2] to the left.
[1]
3) Turn the Coupling (Front) [1] so that the screw comes in front, and then loosen the screw [2]
to move the Coupling (Front) [1] to the right.
[1]
[2]
F-4-166
[2]
F-4-167
4-70
4-70