Preparations; Side Registration Position Fine Adjustment Mode (Shift Amount Change) - Canon Booklet Finisher-D1 Service Manual

5
Adjustment > Auxiliary Adjustment > Side registration position fine adjustment mode (shift amount change) > Preparations
3) By pressing the Push Switch SW383 [1] or SW384 [2], mode can be selected.
Every time SW384 [2] is pressed, "0: Deliver as a stack after aligning on the Process
Tray/1: Deliver as a stack without aligning on the Process Tray" is displayed on LED [3].
SW382
SW381
SW383 SW384 SW385
(-) (+)
[1]
4) Press the Push Switch SW385 [1] to determine the mode, and complete the adjustment.
SW382
SW381
SW383 SW384 SW385
(-) (+)
5 Adjustment > Auxiliary Adjustment > Side registration position fine adjustment mode (shift amount change) > Preparations
[3]
ENTER
[2]
F-5-336
ENTER
[1]
F-5-337
Side registration position fine adjustment mode (shift
amount change)
Execute the adjustment in the following cases.
• When paper corner is bent or caught with custom size paper
NOTE:
By executing this adjustment, shift amount at the time of delivery is adjusted so that
paper corner bend or paper being caught in the Finisher can be avoided.
The operation procedure is shown below.

■ Preparations

1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
5-136
5-136