Adjusting Feeding Distance Of Saddle Disengagement Roller; Preparations; Procedure - Canon Booklet Finisher-D1 Service Manual

5
Adjustment > Auxiliary Adjustment > Adjusting Feeding Distance of Saddle Disengagement Roller > Procedure
Adjusting Feeding Distance of Saddle Disengagement
Roller
Execute this adjustment in the case of displacement in staple position.
NOTE:
Executing this adjustment enables to extend feeding time of paper that is executed
before stapling (rotating time of M101 can be adjusted). With this adjustment, there will
be no abovementioned failure because this adjustment can prevent insufficient feeding
that is caused by slip of the disengagement roller [1].
[1]

■ Preparations

1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
5 Adjustment > Auxiliary Adjustment > Adjusting Feeding Distance of Saddle Disengagement Roller > Procedure
M101
F-5-277

■ Procedure

1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
2) Press switch SW385 [1] so that this adjustment is ready now.
SW382
SW381
SW383 SW384 SW385
(-) (+)
ENTER
F-5-278
ENTER
[1]
F-5-279
5-116
5-116