Removing The Side Registration Shift Unit; Preparation; Procedure - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Feed Assembly > Removing the Side Registration Shift Unit > Procedure
7) Move the Shift Shaft [1] to remove the Side Registration Sensor PCB [2].
• 2 Screws [3]
x2
[1]
4 Parts Replacing and Cleaning > Feed Assembly > Removing the Side Registration Shift Unit > Procedure
[2]
[3]
F-4-102

Removing the Side Registration Shift Unit

■ Preparation

1) Open the Front Cover.
2) Separate the finisher from the host machine.(Refer to page 4-18)
3) Remove the Rear Upper Cover (Right).(Refer to page 4-21)
4) Remove the Rear Upper Cover (Left).(Refer to page 4-21)
5) Remove the Rear Cover.(Refer to page 4-20)
6) Remove the Inner Cover (Upper).(Refer to page 4-22)

■ Procedure

1) Remove the Latch Base Cover [1].
• 3 Screws [2]
[1]
[2]
4-49
F-4-103
4-49