5
Adjustment > Auxiliary Adjustment > Adjusting Staple Position (1-stapling at the front) > Procedure
6) Check that the stapling position is within the specified range [1] of 5 +/- 2mm using this
result. If the stapling position is out of the specification, go through the procedure again
from step 2).
CAUTION:
If the LED indicates anything other than "0" meaning the adjustment failure, execute the
adjustment again.
5
Adjustment > Auxiliary Adjustment > Adjusting Staple Position (1-stapling at the front) > Procedure
[1]
F-5-174
5-76
5-76