Feed Assembly; Removing The Delivery Static Eliminator; Procedure - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Feed Assembly > Removing the Delivery Static Eliminator > Procedure

Feed Assembly

Removing the Delivery Static Eliminator

■ Procedure

1) While supporting the Tray A [1], insert a screwdriver into the hole [A] to release the block
[2] in the direction of [B], and lower the bottom side [C] of the Tray A [1] to the upper end
position [D] of the Neat Stack Unit (Lower) Cover [3].
[1]
[2]
[3]
[A]
[B]
2) Store the following parts of the Neat Stack Unit (Upper) [1].
• 2 Alignment Arms [2]
• 1 Paddle Unit [3]
[1]
4 Parts Replacing and Cleaning > Feed Assembly > Removing the Delivery Static Eliminator > Procedure
[1]
[C]
[D]
[3]
F-4-73
[2]
[3]
[2]
F-4-74
3) Remove the Delivery Static Eliminator [1].
• 1 Screw [2] (to loosen)
• 3 Screws [3] (to remove)
x3
[2]
4-39
[3]
[1]
F-4-75
4-39