Removing The Neat Stack Unit (Upper); Preparation; Procedure - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Neat Stack Unit (Upper) > Procedure
2) Open the Neat Paddle (Lower) Unit [1].
3) Move the belt [2] in the direction of the arrow so that the 2 claws [3] face upward.
NOTE:
If the 2 claws [3] are already facing upward, there is no need to move the belt [2].
4) Remove the 2 Neat Paddles (Lower) [1].
• 2 Claws [2]
x2
[2]
[2]
[1]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Neat Stack Unit (Upper) > Procedure
[1]
[2]
[3]
F-4-127
[1]
F-4-128

Removing the Neat Stack Unit (Upper)

■ Preparation

1) Remove the Stack Wall (Upper).(Refer to page 4-27)

■ Procedure

CAUTION:
When replacing or installing/removing the component parts of the Neat Stack Unit
(Upper), be sure to perform the following adjustment.
• Adjusting the Alignment Position of the Upper Neat Alignment Plate(Refer to page
5-17)
1) Remove the Neat Stack Unit (Upper) Cover (Left) [1].
• 4 Screws [2]
[1]
x4
4-57
[2]
[2]
F-4-129
4-57