Checking The Contents - Canon Booklet Finisher-D1 Service Manual

Checking the Contents

[9] [10] [11]
[12]
[5]
[8]
[3]
1 [1]
[4]
[2]
3 [14]
5 [19]
7
Installation > Checking the Contents
2 [13]
[6]
[7]
4 [15] [16] 4 [17] 4 [18]
[21] 4 [22]
[20]
7 Installation > Checking the Contents
[1]*1 Finisher
[3] Latch Plate (Rear)
[5] Card Spacer
[7] Delivery Guide Down
[9] ARCNET Cable
[11] Shant Cable
[13]*2 Screw (RS tightening;M4x10)
[15]*4 Guide Map Label
[17]*4 LED Lamp Label (EUR only)
[19]*5 Power Cord
[21] Staple Cartridge
*1: The figure shows Booklet Finisher-Q1 PRO.
*2: Use 7 Screws when connecting the Host Machine.
: Use8 Screws whenConnecting the Profesional Puncher Integration Unit or the Paper
Folding Unit or the Document Insertion Unit.
*3: Includeed with Staple Finisher-Q1 PRO only.
*4: Included with Booklet Finisher -Q1 PRO only
*5: Used for Eur destination only. Use the appropriate Power Cord according to the country/
region to install. Be sure to bring back the unused Power Cordes
< CD/Guide :Booklet Finisher-Q1 PRO>
• FCC/IC Sheet (USA only)
• Perchlorate Notice
• Note when unpacking Finisher
• Notice of Battery disposal Information (Taiwan) (Other then USA and CAN.)
< CD/Guide :Booklet Staple Finisher-Q1 PRO>
• Note when unpacking Finisher
• Notice of Battery disposal Information (Taiwan) (Other then USA and CAN.)
F-7-6
1pc [2] Latch Plate (Front)
1pc [4] Postioning Pin
2pc [6] Delivery Guide Up
1pc [8] Screw (P tightening;M4x12)
1pc [10] Coaxial Connector
1pc [12] Wire Saddle
10pc [14]*3 Guide Map Label
1pc [16] Staple Label
1pc [18]*4 Saddle Return Attention Label 1pc
3pc [20] Power Cord (USA only)
1pc [22]*4 Saddle Staple Cartridge
7-4
1pc
1pc
1pc
2pc
1pc
1pc
1pc
1pc
1pc
1pc
7-4