Canon Booklet Finisher-D1 Service Manual page 353

8) Rotate the adjusting bolt with the spaner . Adjust the height (that was measured in step 6))
to be within 86.3 +/-0.3 mm.
• To increase the height: rotate in the direction of [A]
• To lower the height: rotate in the direction of [B]
(Height increment per rotation: approx.1.75 mm)
[A]
Spanner
9) Tighten the fixing nut in the direction of [B].
[B]
10) Adjust the other 3 casters as well (by repeating the steps above).
11) Reconnect the Finisher with the Host Mashine and check the height.
12) Return the Rear Cover to the original possition.
• 8 Screws
7
Installation > Making Adjustments > Height Adjustment > Height Adjustment
Adjusting Bolt
[B]
F-7-81
Fixing Nut
F-7-82
7 Installation > Making Adjustments > Height Adjustment > Height Adjustment
7-31
7-31