Adjustment In The Case Of Failure In Stacking Performance Of Tray (Upper Curl); Preparations; Procedure - Canon Booklet Finisher-D1 Service Manual

5
Adjustment > Adjustment at Time of Parts Replacement > Adjustment in the Case of Failure in Stacking Performance of Tray (upper curl) > Procedure
Adjustment in the Case of Failure in Stacking
Performance of Tray (upper curl)
Execute this adjustment in the case of failure in tray stacking (upper curl) as shown in the
figure below or replacing the finisher controller PCB or when trailing edge of paper is soiled.
NOTE:
Executing this adjustment enables the finisher to increase feeding speed at the timing
that the paper's trail edge reaches the delivery roller.
As a result, the trail edge of paper does not stay around the delivery outlet and the tray
stackability will improve.

■ Preparations

1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
5 Adjustment > Adjustment at Time of Parts Replacement > Adjustment in the Case of Failure in Stacking Performance of Tray (upper curl) > Procedure
F-5-126

■ Procedure

1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
2) Press switch SW385 [1] so that this adjustment is ready now.
SW382
SW381
SW383 SW384 SW385
(-) (+)
ENTER
F-5-127
ENTER
[1]
F-5-128
5-55
5-55