Table of Contents
Advertisement
5
Adjustment > Auxiliary Adjustment > Adjusting Delivery of Staple Stack (saddle delivery) > Procedure
7) If B (displacement amount between the 1st sheet and the 3rd sheet) is out of the specified
value, execute the following work:
Take out the paper and close the upper cover.
Press push switch SW385 [1] once to get into the adjustment mode for B (displacement
amount between the 1nd sheet and the 3rd sheet). Pressing push switch SW383 [2]
reduces the displacement amount while pressing SW384 [3] increases the displacement
amount. (Correction amount is displayed on the LED [4])
• Adjustment range: +48 to -48 (correction amount by 8 units: 1.6mm)
(Adjustment level: amount per 8 units)
Press SW385 again to confirm correction amount for A and B.
SW382
SW381
SW383
SW384 SW385
(-)
(+)
[2]
CAUTION:
Every time you press push switch SW385 while the LED indicates "0", the correction
amount for A and B is alternately displayed on the LED.
During the work, be sure to remember which correction value you are working.
5
Adjustment > Auxiliary Adjustment > Adjusting Delivery of Staple Stack (saddle delivery) > Procedure
[4]
ENTER
[3]
[1]
F-5-193
5-84
5-84
Advertisement
Table of Contents
