Adjusting Position Of Tray A - Canon Booklet Finisher-D1 Service Manual

5
Adjustment > Adjustment at Time of Parts Replacement > Adjusting Position of Tray A, B
Adjusting Position of Tray A, B
This adjustment is executed to keep the parallelism of the Tray A or B when replacing or
installing/removing the tray.
1) While keeping the tray horizontal, put the tray into the rails (left and right).
Be sure to have same distance at distance A (length from the tip [3] of the rail to the tray
shaft [4]) between the front side [1] and the rear side [2] of the tray when installing the tray.
CAUTION:
When lowering the tray, be sure to do so while pulling the block [5].
To stop the lowering, return the block [5].
[3]
[4]
[A]
[5]
5 Adjustment > Adjustment at Time of Parts Replacement > Adjusting Position of Tray A, B
[1]
[2]
F-5-30
5-16
5-16