Canon Booklet Finisher-D1 Service Manual page 338

2) Install positioning Screw.
• 2 Screws (RS tighting; M4x10)
Positioning
Pin
x2
3) Lock the Latch Plate (Front) to the cover. Then, fit the positioning pin of the Integration Unit
to the positioning plate hole on the Finisher to connect.
<Front side>
7
Installation > Installation Procedure > Connecting with the Professional Puncher Integration Unit
F-7-35
Latch Plate(Front)
F-7-36
7 Installation > Installation Procedure > Connecting with the Professional Puncher Integration Unit
<Rear side>
4) Fix the Latch Base (Front).
• 1 Screw (Use the Screw removed in the step 5) of "Before Installing Finisher" )
Screw
7-16
Positioning Pin Hole
F-7-37
Latch Plate(Front)
F-7-38
7-16