Upper/Lower Neat Paddle Position Adjustment - Canon Booklet Finisher-D1 Service Manual

5
Adjustment > Auxiliary Adjustment > Upper/Lower Neat Paddle position adjustment > Procedure

Upper/Lower Neat Paddle position adjustment

This adjustment is executed when stacking failure occurs on the Upper Tray or Lower Tray as
shown in the figure below (paper displacement in the feed direction).
<Stacking failure on the Upper Tray>
<Stacking failure on the Lower Tray>
■ Preparations
1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
5 Adjustment > Auxiliary Adjustment > Upper/Lower Neat Paddle position adjustment > Procedure
F-5-319
F-5-320
■ Procedure
1) Set DIP SW382 [1] on the Switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
2) Press the Push Switch SW385 [1] to complete preparation for the adjustment.
SW382
SW381
SW383 SW384 SW385
(-) (+)
ENTER
F-5-321
ENTER
[1]
F-5-322
5-130
5-130