Canon Booklet Finisher-D1 Service Manual page 222

5
Adjustment > Adjustment at Time of Parts Replacement > Saddle Stitch/Fold Placement Adjustment > Saddle stitch adjustment
2) Hold the lever [1] to pull out the saddle unit [2], and then open the saddle right guide [3].
[2]
[1]
3) Follow the feed guide to set the paper (A4R or LTRR) [1]. (Be sure to push in the paper
until it touches the positioning plate).
5 Adjustment > Adjustment at Time of Parts Replacement > Saddle Stitch/Fold Placement Adjustment > Saddle stitch adjustment
[3]
F-5-102
[2] [1]
F-5-103
4) Press push switch SW384 [1] once to execute stapling.
Note that if the push switch is pressed without the paper on the saddle unit, the machine
goes to the position adjustment mode mentioned in step 7).
SW382
SW381
SW383 SW384 SW385
(-) (+)
5) Take out the paper (that you have set) and measure staple position (A, B).
ENTER
[1]
F-5-104
[A]
[B]
F-5-105
5-46
5-46