Connecting Cable - Canon Booklet Finisher-D1 Service Manual

Connecting Cable

NOTE:
This item is also variably connected to other option machine, but as an example, in this
case, it is connected to the Host machine.
1) Rotate the terminal connector at the back of the Host machine in the direction of the arrow
to remove.
NOTE:
Trailing edge connector is not used in the Integration Unit.
7
Installation > Installation Procedure > Connecting Cable
Terminal Connector
F-7-62
7 Installation > Installation Procedure > Connecting Cable
2) Connect the ARKNET Cable to the terminal at the back of the Host machine, and then
rotate the knob in the direction of the arrow to fix.
CAUTION:
Be sure to turn the knob of the ARCNET Cable all the way to connect otherwise it can
cause unstable electrical contact.
3) Connect the terminal connector and the ARKNET Cable to the coaxial connector, and turn
their knobs in the direction of the arrows as shown in the figure to secure.
x2
ARCNET Cable
7-24
Terminal ARCNET Cable
Knob
F-7-63
Terminal Connector
Coaxial Connector
F-7-64
7-24