Basic Sequence Of Operations - Canon Booklet Finisher-D1 Service Manual

2
Technology > Intermediate Process Tray Assembly > Basic Sequence of Operations
Finisher controller PCB
PS17
[1] Lower delivery sensor signal PS6 : Lower delivery sensor
[2] Handling tray sensor signal PS17 : Process tray paper
2 Technology > Intermediate Process Tray Assembly > Basic Sequence of Operations
[1] [2]
PS6
F-2-23

Basic Sequence of Operations

The intermediary tray block uses the following 4 sequences of operations:
1. Stacking Operation [1]
Deposits sheets coming front the transport block in the intermediary tray.
2. Aligning Operation [2]
Switches over the point of depositing stacks between the front and the rear of the tray. (in
shift mode)
3. Stapling Operation [3]
Staples a stack of sheets at a specific point. (in staple mode)
4. Delivery Operation [4]
Discharges the sheets deposited in the intermediary tray to the tray A or the tray B.
5.Neat Alignment Operation
This is an alignment mechanism that aligns the front and rear edges as well as the feed
direction of paper by using the Alignment Plate and the Return Roller when ejecting paper
to the tray.
The following are the particulars of the individual operations:
[4]
[1]
[2]
[3]
F-2-24
2-19
2-19