Table of Contents
Advertisement
5
Adjustment > Auxiliary Adjustment > Outline
Adjustment Type
Symptom, adjustment timing
Adjusting Paddle
• When stacking failure occurs on the tray with thin
Height
paper
• When staple alignment failure occurs
Adjustment in the Case
When stacking failure occurs on the tray (when upward
of Failure in Stacking
curl occurs)
Performance of Tray
(upper curl)
Adjustment in the Case
When stacking failure occurs on the tray (when
of Failure in Stacking
downward curl occurs)
Performance of Tray
(lower curl)
Adjustment in the Case
When stacking failure occurs on the tray with thin paper
of Failure in Stacking
Performance of Tray
(run-on of paper when
using thin paper)
Adjustment in the Case
When canceling stacking limit of the tray for coated
of Canceling Limit for
paper or extra-large paper
Tray Stack
Adjusting Alignment for
When staple positions (saddle delivery) are displaced
Saddle Stapling
at the rear side and the front side
Adjusting Engagement/
When staple position is displaced significantly
Disengagement
Position of Saddle
Disengagement Roller
Adjusting Feeding
When staple position is displaced
Distance of Saddle
Disengagement Roller
Adjusting Side
When jam occurs frequently at the Saddle Stack Guide
Registration of Saddle
Setting of Pressless
When paper wrinkle occurs
Mode
Adjusting Delivery
When paper is curled
Angle
Setting of Tray Speed When abnormal noise is heard at the time of lifting/
lowering a tray after replacement of the Tray Motor
Changing Lower
When delivering non-stapled papers to the Lower Tray
Delivery Mode
Setting of Stop-less
When paper wrinkle occurs
Stacking
Adjusting Hole
When adjusting the punch hole position from paper
Positions in Feeding
edge
Direction
Upper/Lower Neat
When paper displacement in feed direction occurs with
Paddle position
the Upper Tray or the Lower Tray
adjustment
5
Adjustment > Auxiliary Adjustment > Outline
Reference
Adjustment Type
p. 5-100
Punch skew tolerance
adjustment mode
p. 5-102
Process Tray alignment
operation adjustment
mode with A4R/LTRR
size paper
p. 5-104
Side registration
position fine
adjustment mode (shift
amount change)
p. 5-106
p. 5-108
p. 5-110
p. 5-113
p. 5-115
p. 5-117
p. 5-120
p. 5-121
p. 5-123
p. 5-125
p. 5-127
p. 5-128
p. 5-129
Symptom, adjustment timing
When displacement of hole position (within 8.5 mm)
occurs and paper is skewed on the way from when it
passes through the Delivery Outlet until it is aligned
with the Alignment Plate at the time of delivery.
When prioritizing productivity of A4R and LTRR size
paper with the Lower Tray (without inner punching)
When paper corner is bent or caught with custom size
paper
5-67
Reference
p. 5-132
p. 5-134
p. 5-135
T-5-9
5-67
Advertisement
Table of Contents
