Canon Booklet Finisher-D1 Service Manual page 339

5) Close the Front Cover of the Finisher.
6) Move the Latch Plate (Rear) on the direction of the arrow and insert it to the pin to fix it.
• 1 Screw (Use the Screw removed in the step 7) of "Before Installing Finisher" )
Latch Plate(Rear)
7) Check the height between Finisher and the Integration Unit.
CAUTION:
Height difference should be within +/-2 mm. Execute "Height Adjustment" if the
difference is +/-2 mm or more.
Finisher
7
Installation > Installation Procedure > Connecting with the Professional Puncher Integration Unit
Screw
F-7-39
Integration Unit
F-7-40
7 Installation > Installation Procedure > Connecting with the Professional Puncher Integration Unit
8) Install the Rear Small Cover.
• 1 Screw
9) Install the Shunt Cable.
• 2 Screws (RS tighting; M4x10)
x2
Shunt Cable
7-17
F-7-41
7-17