Connecting With The Paper Folding Unit - Canon Booklet Finisher-D1 Service Manual

Connecting with the Paper Folding Unit

CAUTION:
Be sure the power of the Host Machine is turned OFF and the Power Plug is
disconnected from the outlet.
1) On the Paper Folding Unit's upper left side, install the Latch Plate (Front) Latch Plate (Rear).
• 4 Screws (RS tighting; M4x10)
CAUTION:
Confirm the engraved mark on each Latch Plate when attaching.
Latch Plate (Front) : F
Latch Plate (Rear) : R
x4
Latch Plate(Rear)
7
Installation > Installation Procedure > Connecting with the Paper Folding Unit
Latch Plate(Front)
F-7-42
7 Installation > Installation Procedure > Connecting with the Paper Folding Unit
2) Fit the positioning pin.
• 2 Screws (RS tightening; M4x10)
x2
Positoning Pin
3) Remove the Rear Cover.
• 2 Screws (Loosen)
• 6 Screws
x6
7-18
F-7-43
F-7-44
7-18