Removing The Stack Delivery Motor; Preparation; Procedure; Removing The Process Tray Plate Unit - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Process Tray Plate Unit > Procedure

Removing the Stack Delivery Motor

■ Preparation

1) Remove the Stack Wall (Lower).(Refer to page 4-29)
2) Remove the Stack Wall (Upper).(Refer to page 4-27)
3) Remove the Neat Stack Unit (Lower).(Refer to page 4-59)
4) Remove the Process Tray Unit.(Refer to page 4-62)

■ Procedure

1) Loosen the screw [1] to remove the Stack Delivery Motor [2].
• 1 Connector [3]
• 2 Screws [4]
• 1 Belt [5]
[3]
x2
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Process Tray Plate Unit > Procedure
[1]
[2]
[5]
[4]
[4]
F-4-171

Removing the Process Tray Plate Unit

■ Preparation
1) Remove the Stack Wall (Lower).(Refer to page 4-29)
2) Remove the Stack Wall (Upper).(Refer to page 4-27)
3) Remove the Neat Stack Unit (Lower).(Refer to page 4-59)
4) Remove the Process Tray Unit.(Refer to page 4-62)
■ Procedure
1) Free the harness from the 3 Wire Saddles [1], and disconnect the connector [3].
x3
[1]
[1]
[2]
[3]
4-72
F-4-172
4-72