Canon Booklet Finisher-D1 Service Manual page 266

5
Adjustment > Auxiliary Adjustment > Adjusting Saddle Stitching Position > Procedure
4) Press push switch SW384 [1] once to execute stapling.
Note that if the push switch is pressed without the paper on the saddle unit, the machine
goes to the position adjustment mode mentioned in step 7).
SW382
SW381
SW383 SW384 SW385
(-) (+)
5) Take out the paper (that you have set) and measure staple position (A, B).
5 Adjustment > Auxiliary Adjustment > Adjusting Saddle Stitching Position > Procedure
ENTER
[1]
F-5-207
[A]
[B]
F-5-208
6) If the measured value (A, B) is within the specified range (|A-B| is 0.5mm or less), press
push switch SW385 [1] once to complete the adjustment mode. It the measured value is
out of the specified value, execute the following work.
SW382
SW381
SW383 SW384 SW385
(-) (+)
7) Work with the 2 push switches (SW383, 384) according to displacement amount for the
specified value.
Pressing SW383 [1] moves the staple position upward while pressing SW384 [2] moves the
staple position downward.
• Adjustment range: +10 to -10 (correction amount per unit: 0.125mm)
After the adjustment value is specified, go through the following procedure.
• No paper→the adjustment value is overwritten and the mode terminates.
• Paper present→re-check the staple position and go back to step 4).
ENTER
[1]
F-5-209
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1] [2]
F-5-210
5-90
5-90