Removing The Process Tray Unit; Preparation; Procedure - Canon Booklet Finisher-D1 Service Manual

Hide thumbs Also See for Booklet Finisher-D1:
Table of Contents

Advertisement

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Process Tray Unit > Procedure

Removing the Process Tray Unit

■ Preparation

1) Remove the Stack Wall (Lower).(Refer to page 4-29)
2) Remove the Stack Wall (Upper).(Refer to page 4-27)
3) Remove the Neat Stack Unit (Lower).(Refer to page 4-59)

■ Procedure

1) While supporting the Tray B [1], insert a screwdriver into the hole [A] on the tray's
undersurface to release the block [2] in the direction of [B], and lower the Tray B [1] to the
position as shown in the figure below.
[2]
[A]
[B]
4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Process Tray Unit > Procedure
[1]
F-4-142
CAUTION:
• When removing the Process Tray Unit, hold the 2 grips [1] of the frame, and release
the 2 hooks [2] from the 2 holes of the frame on the host machine side.
[2]
[1]
4-62
[2]
F-4-143
4-62

Advertisement

Table of Contents
loading

This manual is also suitable for:

Staple finisher-d1

Table of Contents