Side Registration Adjustment - Canon Booklet Finisher-D1 Service Manual

5
Adjustment > Basic Adjustment > Side Registration/Skew Adjustment > Side registration adjustment
3) The LED [1] displays the adjustment value for side registration/skew.
Check each value. The display shows values in the order of "A" -> "side registration
adjustment value" -> "B" -> "skew adjustment value".
• Side registration adjustment range (estimated value); -3 to +3 mm (1 scale is
equivalent to 1mm).
• Skew adjustment range (estimated value); -2 to +2 mm (1 scale is equivalent to 1mm).
SW382
SW381
SW383 SW384 SW385
(-) (+)
4) Press ENTER button to complete the adjustment mode.
If the adjustment value (estimated value) is within the range, set the DIP switch back and
complete the adjustment. If the adjustment value (estimated value) is out of the range,
execute "2. Side registration adjustment" or "3. Skew adjustment".
5) Turn OFF the power switch of the host machine then the finisher.
5 Adjustment > Basic Adjustment > Side Registration/Skew Adjustment > Side registration adjustment
[1]
ENTER
F-5-14

■ Side registration adjustment

1) Separate the finisher from the host machine.
2) Loosen the 2 screws [2] on the positioning plate [1] at the right side.
3) If the value obtained at "checking adjustment value" is "+ (positive)", move it in [A] direction
and tighten the screws [2].
If the value obtained at "checking adjustment value" is "- (negative)", move it in [B] direction
and tighten the screws [2].
[2]
5-7
[1]
[B] [A]
F-5-15
5-7