Removing The Upper Feed Unit; Preparation; Procedure - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Feed Assembly > Removing the Upper Feed Unit > Procedure

Removing the Upper Feed Unit

■ Preparation

1) Remove the Stack Wall (Upper).(Refer to page 4-27)
2) Remove the Neat Stack Unit (Upper).(Refer to page 4-57)
3) Remove the Rear Upper Cover (Right).(Refer to page 4-21)
4) Remove the Rear Upper Cover (Left).(Refer to page 4-21)
5) Remove the Rear Cover.(Refer to page 4-20)
6) Open the Front Cover.

■ Procedure

1) Remove the Fan Unit [1].
• 1 Connector [2]
• 1 Screw [3]
[1]
[2]
4 Parts Replacing and Cleaning > Feed Assembly > Removing the Upper Feed Unit > Procedure
[3]
F-4-76
2) Disconnect the 2 Grounding Wires [1].
• 2 Screws [2]
3) Free the harness [3].
• 2 Connectors [4]
• 1 Edge Saddle [5]
• 1 Reuse Band [6]
• 4 Wire Saddles [7]
[5]
x2
[6]
[7]
x6
[3]
[4]
4) Remove the Shaft Retainer Plate [1].
• 1 Screw [2]
4-40
[1]
[2]
[7]
[7]
[1]
x2
F-4-77
[2]
[1]
F-4-78
4-40