Removing The Neat Paddle (Lower); Procedure - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Neat Paddle (Lower) > Procedure
3) Open the Neat Paddle (Upper) Unit [1].
4) Move the belt [2] in the direction of the arrow so that the 2 claws [3] face upward.
NOTE:
If the 2 claws [3] are already facing upward, there is no need to move the belt [2].
5) 5) Remove the 2 Neat Paddles (Upper) [1].
• 2 Claws [2]
[2]
x2
[2]
[1]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Neat Paddle (Lower) > Procedure
[1]
[2]
[3]
F-4-124
[1]
F-4-125

Removing the Neat Paddle (Lower)

■ Procedure

1) While supporting the Tray B [1], insert a screwdriver into the hole [A] to release the block [2]
in the direction of [B], and lower the Tray B [1] by approximately 10 cm from the lower edge
of the Neat Stack Unit (Lower) Cover [3].
[3]
[1]
4-56
[2]
[B]
[A]
F-4-126
4-56