Preparations; Procedure; Process Tray Alignment Operation Adjustment Mode With A4R/Ltrr - Canon Booklet Finisher-D1 Service Manual

5
Adjustment > Auxiliary Adjustment > Process Tray alignment operation adjustment mode with A4R/LTRR size paper > Procedure
Process Tray alignment operation adjustment mode
with A4R/LTRR size paper
Execute the adjustment in the following cases.
• When prioritizing productivity of A4R and LTRR size paper with the Lower Tray (without
inner punching)
NOTE:
By executing this adjustment, alignment operation at the Process Tray Assembly is
omitted; therefore, productivity is prioritized over stacking accuracy.
The operation procedure is shown below.

■ Preparations

1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
5 Adjustment > Auxiliary Adjustment > Process Tray alignment operation adjustment mode with A4R/LTRR size paper > Procedure

■ Procedure

1) Set DIP SW382 [1] on the Switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
2) Press the Push Switch SW385 [1] to complete preparation for the adjustment.
SW382
SW381
SW383 SW384 SW385
(-) (+)
ENTER
F-5-334
ENTER
[1]
F-5-335
5-135
5-135