Adjusting The Alignment Position Of The Lower Neat Alignment Plate; Preparations; Procedure - Canon Booklet Finisher-D1 Service Manual

5
Adjustment > Adjustment at Time of Parts Replacement > Adjusting the Alignment Position of the Lower Neat Alignment Plate > Procedure
5 Adjustment > Adjustment at Time of Parts Replacement > Adjusting the Alignment Position of the Lower Neat Alignment Plate > Procedure
Adjusting the Alignment Position of the Lower Neat
Alignment Plate
Execute the adjustment in the following cases.
• When replacing or installing/removing the Neat Stack Unit (Lower) and the component
parts of the unit.
• When replacing the Finisher Controller PCB.
Adjusting method is as follows:

■ Preparations

1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).

■ Procedure

1) Set DIP SW382 [1] on the Switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-37
5-19
5-19