Table of Contents
Advertisement
5
Adjustment > Auxiliary Adjustment > Adjusting Side Registration of Saddle > Procedure
3-5) Determine the actual measurement value (distance between the feed front side
plate and the saddle front side plate) using a scale.
3-6) Calculate displacement amount of the saddle stack guide using the reference value
(23.8mm) and the actual measurement value (displacement amount = actual
measurement value - reference value).
Example)
In the case that the measurement value is 25mm
Displacement amount = 25 - 23.8 = 1.2mm
4) Calculate correction amount of the shift unit using the displacement amount of the saddle
stack guide.
Example)
In the case that the displacement amount is 1.2
The displacement amount in positive value means that the saddle stack guide is
displaced to the rear.
1 increment changes by 0.5mm in service mode.
In this case, the correction amount is +2.
Slide the shift unit to the rear in service mode as shown below so that the feeding
paper will not be caught in the hole of the stack guide.
5
Adjustment > Auxiliary Adjustment > Adjusting Side Registration of Saddle > Procedure
5) Pressing switch SW383 [1] or SW384 [2] determines adjustment level.
By pressing SW383 once, the LED [3] indicates "-1" and the shift unit [4] slides to the front
as shown in the figure below (- direction).
In the same way, by pressing SW384 once, the LED [3] indicates "+1" and the shift unit [4]
slides to the rear as shown in the figure below (+direction).
• Adjustment range: -10 to +10 (0.5mm-change per unit)
[4]
F-5-288
6) Press switch SW385 [1] again to complete this adjustment.
SW382
SW381
SW383
SW384 SW385
(-)
(+)
ENTER
[1]
[2]
SW382
SW381
SW383
SW384 SW385
(-)
(+)
ENTER
[1]
F-5-290
5-120
[3]
F-5-289
5-120
Advertisement
Table of Contents
