Canon Booklet Finisher-D1 Service Manual page 101

4
Parts Replacing and Cleaning > Stacking Assembly > Removing the Tray A/B Lifting Motor
2) While supporting the tray from below, release the block [1] in the direction of the arrow, and
lower the tray until it hits the bottom.
CAUTION:
Be sure to lower the Tray Unit to the bottom beforehand because removing the Tray A/
B Lifting Motor loosens tension of the belt, causing the Tray Unit to fall.
[1]
3) Remove the screw [2], and remove the Connector Cover [1].
4 Parts Replacing and Cleaning > Stacking Assembly > Removing the Tray A/B Lifting Motor
F-4-69
[2]
[1]
F-4-70
4) Disconnect the connector [1], and free the harness [4] from the Edge Saddle [2] and the
Wire Saddle [3].
x2
[3]
5) Remove the Tray A/B Lifting Motor [1].
• 2 Screws [2]
• 1 Belt [3]
[3]
[1]
[4]
[2]
F-4-71
[1]
[2]
F-4-72
4-38
4-38