Canon Booklet Finisher-D1 Service Manual page 344

2) Install positioning Screw.
• 2 Screws (RS tighting; M4x10)
x2
Positioning Pin
3) Lock the Latch Base (Front) to the cover. Then, fit the positioning pin of the Document
Insertion Unit to the positioning plate hole on the Finisher to connect.
<Front side>
7
Installation > Installation Procedure > Connecting with the Document Insertion Unit
F-7-55
Latch Plate(Front)
F-7-56
7 Installation > Installation Procedure > Connecting with the Document Insertion Unit
<Rear side>
4) Secure the Latch Plate (Front).
• 1 Screw (Use the Screw removed in the step 5) of "Before Installing Finisher" )
Screw
7-22
Positioning Pin Hole
F-7-57
Latch Plate(Front)
F-7-58
7-22