Making Adjustments
Height Adjustment
Depending on the floor condition of the installation site, the hight of the Finisher needs to
be adjusted. If not properly adjusted, paper can be jammed more frequently in the Finisher
Pickup Assembly. Follow the steps below to adjust the hight if necessary.
■ Checking the height
1) Turn OFF the Main Power Switch of the machine and Finisher.
2) Check the height of the Finisher and the Host Machine. The height difference between the
Right top of the Finisher and the Left top of the Host Machine should be within +/-2 mm.
Left top of the Host Machine
Right top of the
Finisher
7
Installation > Making Adjustments > Height Adjustment > Checking the height
F-7-72
7
Installation > Making Adjustments > Height Adjustment > Checking the height
3) If the difference exceeds +/-2 mm range, adjust the height.
NOTE:
Adjust the height with 4 casters as shown in the figure.
Casters
7-28
Casters
F-7-73
7-28