Removing The Belt Controller Unit; Preparation; Procedure - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Belt Controller Unit > Procedure
4) Fit the 2 Support Pins [1] of the Process Upper Guide Unit to the 2 grooves [A] of
the finisher.
[1]
[A]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Belt Controller Unit > Procedure

Removing the Belt Controller Unit

■ Preparation

1) Remove the Stack Wall (Lower).(Refer to page 4-29)
2) Remove the Stack Wall (Upper).(Refer to page 4-27)
3) Remove the Neat Stack Unit (Lower).(Refer to page 4-59)
[1]
4) Remove the Process Tray Unit.(Refer to page 4-62)
5) Remove the Rear Cover.(Refer to page 4-20)
6) Open the Front Cover.
7) Remove the Inner Cover (Upper).(Refer to page 4-22)
8) Remove the Process Upper Guide Unit.(Refer to page 4-78)

■ Procedure

[A]
CAUTION:
F-4-191 • Avoid deformation of the 2 Process Upper Guides [1] and the 4 Paper Guides [2].
• Put the removed Process Upper Guide Units [3] with the Belt Controller Unit [4] side
up. Place a stack of paper (approx. 2 cm thick) or cardboards [6] under the handle [5]
to make it stabilized.
[1]
[1]
[3]
[2]
[6]
[5]
[2]
4-81
[3]
[4]
F-4-192
4-81