Canon Booklet Finisher-D1 Service Manual page 210

5
Adjustment > Adjustment at Time of Parts Replacement > Adjusting Staple Position (1-stapling at the front) > Procedure
3) Pressing switch SW383 [1] or SW384 [2] determines adjustment level.
By pressing SW383 once, the LED [3] indicates "-1" and the stapling position at the front
shifts to the rear. In the same way, by pressing SW384 once, the LED [3] indicates "+1" and
the stapling position at the front shifts to the front.
• Adjustment range: +20 to -20 (shifting amount per unit: 0.5mm)
SW382
SW381
SW383 SW384 SW385
(-) (+)
[1]
4) Press push switch SW385 [1] to move the stapler to the front.
SW382
SW381
SW383 SW384 SW385
(-) (+)
5 Adjustment > Adjustment at Time of Parts Replacement > Adjusting Staple Position (1-stapling at the front) > Procedure
[3]
ENTER
[2]
F-5-75
ENTER
[1]
F-5-76
5) Place A4 paper [1] on the intermediate process tray (Be sure to push in the paper to the
rear side of the process tray).
Then, press switch SW383 [1] to execute stapling.
5-34
[1]
F-5-77
5-34