Removing The Stapler; Preparation; Procedure - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Stapler > Procedure
3) Remove the 4 screws [1], and remove the Neat Stack Unit (Lower) [2].
• 2 Pins [3]
x4
[1]
CAUTION:
When putting down the Neat Stack Unit (Lower), be sure to place the unit with the 2
Alignment Plates [1] facing up.
[1]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Stapler > Procedure
[3]
[3]
[2]
F-4-136
[1]
F-4-137

Removing the Stapler

■ Preparation

1) Open the Front Cover.
2) Remove the Inner Cover (Upper).(Refer to page 4-22)
3) Remove the Inner Cover (Lower).(Refer to page 4-23)

■ Procedure

CAUTION:
When replacing or installing/removing the Stapler, be sure to perform the following
adjustment.
• Adjusting the Stapler Position (Refer to page 4-61)
1) Remove the Switch PCB Unit [1].
• 2 Screws [2]
• 1 Edge Saddle [3]
• 1 Connector [4]
4-60
[5]
x2
[2]
[1]
[4]
[3]
F-4-138
4-60