Intermediate Process Tray Assembly; Removing The Stack Delivery Roller Upper Static Eliminator; Procedure; Removing The Neat Paddle (Upper) - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Neat Paddle (Upper) > Procedure

Intermediate Process Tray Assembly

Removing the Stack Delivery Roller Upper Static
Eliminator

■ Procedure

1) While supporting the Tray B [1], insert a screwdriver into the hole [A] to release the block [2]
in the direction of [B], and lower the Tray B [1] by approximately 15cm from the lower edge
of the Neat Stack Unit (Lower) Cover [3].
[3]
[1]
2) Remove the Stack Delivery Roller Upper Static Eliminator [1].
• 4 Screws [2]
x4
[1]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Neat Paddle (Upper) > Procedure
[2]
[B]
[A]
F-4-120
[2]
F-4-121

Removing the Neat Paddle (Upper)

■ Procedure
1) While supporting the Tray B [1], insert a screwdriver into the hole [A] to release the block [2]
in the direction of [B], and lower the Tray B [1] by approximately 10 cm from the lower edge
of the Neat Stack Unit (Lower) Cover [3].
[3]
[1]
2) While supporting the Tray A [1], insert a screwdriver into the hole [A] to release the block
[2] in the direction of [B], and lower the upper side [C] of the Tray A [1] to the upper end
position [D] of the Neat Stack Unit (Lower) Cover [3].
[3]
[1]
4-55
[2]
[B]
[A]
F-4-122
[2]
[B]
[A]
F-4-123
4-55