Adjusting Height Of Staple Inlet Guide; Preparations; Procedure - Canon Booklet Finisher-D1 Service Manual

5
Adjustment > Auxiliary Adjustment > Adjusting Height of Staple Inlet Guide > Procedure

Adjusting Height of Staple Inlet Guide

Execute this adjustment if meeting the following conditions:
• In the case of failure in tray stacking with thin paper as shown in the figure below.
• In the case of alignment fault in stapling.

■ Preparations

1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
5 Adjustment > Auxiliary Adjustment > Adjusting Height of Staple Inlet Guide > Procedure
F-5-229

■ Procedure

1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
2) Press SW385 [1] so that the height adjustment for staple inlet guide is ready now.
SW382
SW381
SW383 SW384 SW385
(-) (+)
ENTER
F-5-230
ENTER
[1]
F-5-231
5-99
5-99