Height Adjustment - Canon Booklet Finisher-D1 Service Manual

■ Height Adjustment

1) Separate the Finisher from the Host Machine.
• Disconnect the Power Plig from the outlet.
• Disconnect the Power Cable of the Finisher.
• Remove the Wire Saddle at the Rear Lower Cover of the Finisher and disconnect the
ARCNET Cable.
• Remove the Latch Plates. (the front and rear)
2) Remove the Spanner from the Finisher Front Cover.
• 1 Screw
Spanner
Screw
7
Installation > Making Adjustments > Height Adjustment > Height Adjustment
F-7-74
7 Installation > Making Adjustments > Height Adjustment > Height Adjustment
3) In the case of the Saddle Finisher, remove the Saddle Inner Cover (lower).
• 1 Screw
• 1 knob
• 3 Screws
x4
ビス
Knob
4) Remove the 2 caster covers at the Left side. (Figure shows in the case of using the
Saddle Finisher)
• 2 Screws
x2
Caster
7-29
Saddle Inner Cover(lower)
F-7-75
Caster
F-7-76
7-29